The Epson XP-900 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson XP-900 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson XP-900 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-900 waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson XP-900 Waste Ink Counter in 3 Steps

1. Step 1: Connect Epson XP-900 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-900 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-900.

Most Epson XP-900 waste counter resets finish in ~1–2 minutes.

System Requirements

• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)

Common Fixes

• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.