Epson XP-446 Waste Ink Counter Reset
The Epson XP-446 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.
During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-446 uses a software counter to estimate pad saturation and locks printing at a set threshold.
Why the Epson XP-446 Stops Printing (Waste Counter Limit)
Most Epson XP-446 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.
Typical Signs
- Printer refuses to print even with ink available
- Epson Status Monitor shows maintenance warning
- Blinking lights and blocked jobs
- Device is locked until reset is performed
Epson XP-446 Ink Pad Counter Reset – Quick Steps
- Step 1: Prepare a Windows PC + USB cable and connect Epson XP-446 directly. Keep Internet enabled for validation.
- Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-446.
- Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-446.
Most Epson XP-446 waste counter resets finish in ~1–2 minutes.
System Requirements
- Valid Wic Reset Connect reset key
- Windows 7/8/10/11 PC
- Stable Internet connection during reset
- USB connection required (Wi-Fi reset not supported)
Frequently Asked Questions
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Guide prepared for Epson XP-446 – Waste Ink Counter Reset using Wic Reset Connect.
English 
Deutsch 
Italiano 
Français 
Українська 
Română 
Español 
Magyar 
Български