The Epson XP-242 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson XP-242 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson XP-242 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson XP-242 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson XP-242 Waste Counter Reset

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-242 via USB (Wi-Fi reset is not supported).
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-242 appears in the device list.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson XP-242 to finalize.

Most Epson XP-242 waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions