Blog

Epson XP-214 Reset Waste Ink Counter

  • Auteur/autrice de la publication :
  • Commentaires de la publication :0 commentaire
Fix Epson XP-214 Service Required – Waste Counter Reset

Epson XP-214 Waste Ink Counter Reset

The Epson XP-214 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-214 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-214 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-214 waste counter reset in minutes.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Epson XP-214 Ink Pad Counter Reset – Quick Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson XP-214 directly. Keep Internet enabled for validation.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-214 appears in the device list.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson XP-214 to finalize.
Buy Wic Reset Key

Most Epson XP-214 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset

FAQ

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson XP-214 – Waste Ink Counter Reset using Wic Reset Connect.

Laisser un commentaire