When the Epson TX730WD reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX730WD tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson TX730WD Waste Ink Counter

With Wic Reset Connect, you can reset the Epson TX730WD waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Reset Epson TX730WD Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson TX730WD directly. Keep Internet enabled for validation.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX730WD appears in the device list.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson TX730WD to finalize.

Most Epson TX730WD waste counter resets finish in ~1–2 minutes.

System Requirements

• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC

Common Fixes

• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.

FAQ