When the Epson R2880 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson R2880 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson R2880 Stops Printing (Waste Counter Limit)

Most Epson R2880 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson R2880 Ink Pad Counter Reset – Quick Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson R2880 via USB (Wi-Fi reset is not supported).
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson R2880.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson R2880 to finalize.

Most Epson R2880 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)

Common Fixes

• Temporarily disable VPN/proxy if validation fails.
• Restart printer and PC, then try again.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions