When the Epson NX300 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson NX300 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson NX300 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson NX300 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson NX300 Ink Pad Counter Reset – Quick Steps

1. Step 1: Connect Epson NX300 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson NX300 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson NX300.

Most Epson NX300 waste counter resets finish in ~1–2 minutes.

What You Need

• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Run the app as Administrator.
• Temporarily disable VPN/proxy if validation fails.