When the Epson L3107 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L3107 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson L3107 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L3107 waste counter reset in minutes.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson L3107 Waste Counter Reset

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson L3107 via USB (Wi-Fi reset is not supported).
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson L3107 appears in the device list.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson L3107.

Most Epson L3107 waste counter resets finish in ~1–2 minutes.

Troubleshooting

• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions