Blog

Epson BX525WD Reset Waste Ink Counter

  • Auteur/autrice de la publication :
  • Commentaires de la publication :0 commentaire
Reset Epson BX525WD Waste Ink Counter in Minutes

Epson BX525WD Waste Ink Counter Reset

If your Epson BX525WD suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson BX525WD uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson BX525WD Stops Printing (Waste Counter Limit)

Most Epson BX525WD waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson BX525WD Waste Counter Reset

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson BX525WD directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson BX525WD.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson BX525WD.
Buy Wic Reset Key

Most Epson BX525WD waste counter resets finish in ~1–2 minutes.

Before You Begin

  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson BX525WD – Waste Ink Counter Reset using Wic Reset Connect.

Laisser un commentaire