Blog

Epson XP-433 Reset Waste Ink Counter

Fix Epson XP-433 Service Required – Waste Counter Reset

Epson XP-433 Waste Ink Counter Reset

The Epson XP-433 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson XP-433 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson XP-433 Stops Printing (Waste Counter Limit)

Most Epson XP-433 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Reset Epson XP-433 Waste Ink Counter in 3 Steps

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-433 via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-433 appears in the device list.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson XP-433 to finalize.
Buy Wic Reset Key

Most Epson XP-433 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key

Frequently Asked Questions

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson XP-433 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply