Blog

Epson WorkForce 42 Reset Waste Ink Counter

Epson WorkForce 42 Ink Pad Counter Reset Guide

Epson WorkForce 42 Waste Ink Counter Reset

If your Epson WorkForce 42 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WorkForce 42 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson WorkForce 42 Waste Ink Counter

Most Epson WorkForce 42 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson WorkForce 42 Printing

  1. Step 1: Connect Epson WorkForce 42 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson WorkForce 42 is detected.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WorkForce 42.
Buy Wic Reset Key

Most Epson WorkForce 42 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson WorkForce 42 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply