Blog

Epson WF-2010 Reset Waste Ink Counter

How to Reset Epson WF-2010 Waste Ink Counter

Epson WF-2010 Waste Ink Counter Reset

The Epson WF-2010 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson WF-2010 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson WF-2010 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson WF-2010 waste counter reset in minutes.

How the Error Appears

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Three Steps to Restore Epson WF-2010 Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson WF-2010 via USB (Wi-Fi reset is not supported).
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson WF-2010 is detected.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson WF-2010.
Buy Wic Reset Key

Most Epson WF-2010 waste counter resets finish in ~1–2 minutes.

What You Need

  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson WF-2010 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply