The Epson TX620FWD is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson TX620FWD tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson TX620FWD Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX620FWD waste counter reset in minutes.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson TX620FWD Waste Counter Reset

1. Step 1: Prepare a Windows PC + USB cable and connect Epson TX620FWD directly. Keep Internet enabled for validation.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson TX620FWD.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson TX620FWD to finalize.

Most Epson TX620FWD waste counter resets finish in ~1–2 minutes.

System Requirements

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset

Common Fixes

• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.
• Restart printer and PC, then try again.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).