Blog

Epson TX525FW Reset Waste Ink Counter

Fix Epson TX525FW Service Required – Waste Counter Reset

Epson TX525FW Waste Ink Counter Reset

When the Epson TX525FW reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson TX525FW accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson TX525FW Stops Printing (Waste Counter Limit)

Most Epson TX525FW waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson TX525FW Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX525FW via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX525FW appears in the device list.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX525FW.
Buy Wic Reset Key

Most Epson TX525FW waste counter resets finish in ~1–2 minutes.

Troubleshooting

  • Restart printer and PC, then try again.
  • Try another USB cable (some cables are charge-only).
  • Temporarily disable VPN/proxy if validation fails.
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).

Frequently Asked Questions

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson TX525FW – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply