Blog

Epson TX320F Reset Waste Ink Counter

Epson TX320F Ink Pad Counter Reset Guide

Epson TX320F Waste Ink Counter Reset

If your Epson TX320F suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

A waste ink counter in the Epson TX320F accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Understanding the Epson TX320F Waste Ink Counter

With Wic Reset Connect, you can reset the Epson TX320F waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson TX320F Printing

  1. Step 1: Connect Epson TX320F to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX320F appears in the device list.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX320F.
Buy Wic Reset Key

Most Epson TX320F waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Temporarily disable VPN/proxy if validation fails.
  • Use a direct USB connection (avoid hubs).
  • Run the app as Administrator.

FAQ

How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson TX320F – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply