The Epson TX300F is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX300F uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson TX300F Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX300F waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson TX300F Waste Ink Counter in 3 Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX300F via USB (Wi-Fi reset is not supported).
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX300F is detected.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson TX300F to finalize.

Most Epson TX300F waste counter resets finish in ~1–2 minutes.

Before You Begin

• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.

FAQ