When the Epson SX409 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson SX409 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson SX409 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson SX409 waste counter reset in minutes.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson SX409 Waste Ink Counter in 3 Steps

1. Step 1: Connect Epson SX409 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson SX409.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson SX409.

Most Epson SX409 waste counter resets finish in ~1–2 minutes.

What You Need

• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC

If the Printer Is Not Detected

• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Restart printer and PC, then try again.
• Use a direct USB connection (avoid hubs).

Frequently Asked Questions