When the Epson PX710W reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson PX710W tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson PX710W Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson PX710W waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson PX710W Ink Pad Counter Reset – Quick Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson PX710W directly. Keep Internet enabled for validation.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson PX710W appears in the device list.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson PX710W.

Most Epson PX710W waste counter resets finish in ~1–2 minutes.

System Requirements

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset

If the Printer Is Not Detected

• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Restart printer and PC, then try again.

Frequently Asked Questions