Blog

Epson NX230 Reset Waste Ink Counter

How to Reset Epson NX230 Waste Ink Counter

Epson NX230 Waste Ink Counter Reset

The Epson NX230 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson NX230 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson NX230 Waste Ink Counter

Most Epson NX230 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Epson NX230 Ink Pad Counter Reset – Quick Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson NX230 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson NX230.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson NX230.
Buy Wic Reset Key

Most Epson NX230 waste counter resets finish in ~1–2 minutes.

Troubleshooting

  • Use a direct USB connection (avoid hubs).
  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.

FAQ

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson NX230 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply