Blog

Epson ME-520 Reset Waste Ink Counter

Fix Epson ME-520 Service Required – Waste Counter Reset

Epson ME-520 Waste Ink Counter Reset

When the Epson ME-520 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson ME-520 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why Does the Epson ME-520 Show ‘Service Required’?

Most Epson ME-520 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Epson ME-520 Ink Pad Counter Reset – Quick Steps

  1. Step 1: Connect Epson ME-520 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson ME-520 appears in the device list.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ME-520.
Buy Wic Reset Key

Most Epson ME-520 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key

Troubleshooting

  • Try another USB cable (some cables are charge-only).
  • Restart printer and PC, then try again.
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).
  • Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson ME-520 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply