Blog

Epson L360 Reset Waste Ink Counter

Epson L360 Ink Pad Counter Reset Guide

Epson L360 Waste Ink Counter Reset

The Epson L360 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L360 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson L360 Ink Pad Counter Warning?

Most Epson L360 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Reset Epson L360 Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson L360 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L360.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson L360 to finalize.
Buy Wic Reset Key

Most Epson L360 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson L360 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply