When the Epson L3119 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L3119 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson L3119 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson L3119 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Reset Epson L3119 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson L3119 directly. Keep Internet enabled for validation.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson L3119 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L3119.

Most Epson L3119 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Try another USB cable (some cables are charge-only).