Blog

Epson L110 Reset Waste Ink Counter

Epson L110 Ink Pad Counter Reset Guide

Epson L110 Waste Ink Counter Reset

When the Epson L110 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L110 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson L110 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L110 waste counter reset in minutes.

How the Error Appears

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson L110 Ink Pad Counter Reset – Quick Steps

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson L110 via USB (Wi-Fi reset is not supported).
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson L110 is detected.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson L110.
Buy Wic Reset Key

Most Epson L110 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson L110 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply