When the Epson ET-M2129 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ET-M2129 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson ET-M2129 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson ET-M2129 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson ET-M2129 Waste Counter Reset

1. Step 1: Connect Epson ET-M2129 to a Windows computer with a stable Internet connection using a USB cable.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-M2129.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-M2129.

Most Epson ET-M2129 waste counter resets finish in ~1–2 minutes.

System Requirements

• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key

Troubleshooting

• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.
• Close Epson Status Monitor or other printer utilities.
• Try another USB cable (some cables are charge-only).

Frequently Asked Questions