Blog

Epson ET-2715 Reset Waste Ink Counter

Reset Epson ET-2715 Waste Ink Counter in Minutes

Epson ET-2715 Waste Ink Counter Reset

When the Epson ET-2715 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ET-2715 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson ET-2715 Stops Printing (Waste Counter Limit)

Most Epson ET-2715 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Reset Epson ET-2715 Waste Ink Counter in 3 Steps

  1. Step 1: Connect Epson ET-2715 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2715.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson ET-2715.
Buy Wic Reset Key

Most Epson ET-2715 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC

FAQ

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson ET-2715 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply