Blog

Epson EP-903F Reset Waste Ink Counter

Fix Epson EP-903F Service Required – Waste Counter Reset

Epson EP-903F Waste Ink Counter Reset

When the Epson EP-903F reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson EP-903F tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson EP-903F Stops Printing (Waste Counter Limit)

Most Epson EP-903F waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson EP-903F Ink Pad Counter Reset – Quick Steps

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson EP-903F via USB (Wi-Fi reset is not supported).
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson EP-903F.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson EP-903F.
Buy Wic Reset Key

Most Epson EP-903F waste counter resets finish in ~1–2 minutes.

System Requirements

  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset

Common Fixes

  • Use a direct USB connection (avoid hubs).
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.
  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson EP-903F – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply