The Epson EP-707A is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson EP-707A uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson EP-707A Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson EP-707A waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson EP-707A Ink Pad Counter Reset – Quick Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson EP-707A via USB (Wi-Fi reset is not supported).
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson EP-707A appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson EP-707A.

Most Epson EP-707A waste counter resets finish in ~1–2 minutes.

Before You Begin

• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• Stable Internet connection during reset

Common Fixes

• Close Epson Status Monitor or other printer utilities.
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.

Frequently Asked Questions