Blog

Epson CX8300 Reset Waste Ink Counter

Fix Epson CX8300 Service Required – Waste Counter Reset

Epson CX8300 Waste Ink Counter Reset

When the Epson CX8300 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson CX8300 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

What Causes the Epson CX8300 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson CX8300 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson CX8300 Printing

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson CX8300 directly. Keep Internet enabled for validation.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson CX8300 is detected.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson CX8300 to finalize.
Buy Wic Reset Key

Most Epson CX8300 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Use a direct USB connection (avoid hubs).
  • Restart printer and PC, then try again.
  • Close Epson Status Monitor or other printer utilities.
  • Run the app as Administrator.
  • Try another USB cable (some cables are charge-only).

FAQ

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson CX8300 – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply