Blog

Epson B42WD Reset Waste Ink Counter

Epson B42WD Waste Ink Counter Reset

Epson B42WD Waste Ink Counter Reset

When the Epson B42WD reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson B42WD tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson B42WD Waste Ink Counter

With Wic Reset Connect, you can reset the Epson B42WD waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson B42WD Waste Counter Reset

  1. Step 1: Connect Epson B42WD to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson B42WD appears in the device list.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson B42WD to finalize.
Buy Wic Reset Key

Most Epson B42WD waste counter resets finish in ~1–2 minutes.

FAQ

How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson B42WD – Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply