When Canon TS9080 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon TS9080 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon TS9080. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon TS9080

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

For best results, avoid rushing button presses—consistent timing matters.

Common Fixes

• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.

FAQ