Blog

Canon TS9050 Ink Absorber Full Reset

TS9050 Waste Ink Counter Reset (Canon Printers)

Canon TS9050 Ink Absorber Full Reset

Canon TS9050 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS9050. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

How to Enter Service Mode on Canon TS9050

To access maintenance functions, Canon TS9050 may need to be placed in service mode first.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 5 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Important Notes

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

  • Power-cycle the printer and try again.
  • Close other Canon printer utilities while resetting.
  • Repeat the service mode steps carefully (timing matters).
  • Use the correct Stop/Reset press count for your series.
  • Try a different USB cable/port if using PC software.

FAQ

How long does it take?
Usually a few minutes once the correct steps are followed.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon TS9050 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply