When Canon TS7450 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS7450. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon TS7450

To access maintenance functions, Canon TS7450 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Troubleshooting

• Use the correct Stop/Reset press count for your series.
• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Try a different USB cable/port if using PC software.
• Close other Canon printer utilities while resetting.

FAQ