The “Ink Absorber Full” / service required message on Canon TS6365 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS6365. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon TS6365

If your Canon TS6365 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Before You Continue

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

• Power-cycle the printer and try again.
• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.

FAQ