When Canon TS6340 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS6340. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon TS6340

To access maintenance functions, Canon TS6340 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Important Notes

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

• Repeat the service mode steps carefully (timing matters).
• Close other Canon printer utilities while resetting.
• Use the correct Stop/Reset press count for your series.
• Try a different USB cable/port if using PC software.
• Power-cycle the printer and try again.

FAQ