When Canon TS5352 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS5352. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon TS5352

To access maintenance functions, Canon TS5352 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

Once the counter is cleared, Canon TS5352 should exit the locked state and printing should resume normally.

Warnings

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

If your model does not show a service mode section, it means no matching procedure was found for its series.

Troubleshooting

• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.
• Repeat the service mode steps carefully (timing matters).
• Close other Canon printer utilities while resetting.
• Power-cycle the printer and try again.

FAQ