Blog

Canon TS5333 Ink Absorber Full Reset

Canon TS5333 Reset Ink Absorber – Complete Tutorial

Canon TS5333 Ink Absorber Full Reset

If your Canon TS5333 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS5333. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

How to Enter Service Mode on Canon TS5333

Some Canon series require entering service mode before the ink absorber counter can be reset.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 5 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Maintenance Reminder

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Frequently Asked Questions

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How long does it take?
Usually a few minutes once the correct steps are followed.

Guide prepared for Canon TS5333 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply