Blog

Canon TS5090 Ink Absorber Full Reset

How to Reset Ink Absorber on Canon TS5090

Canon TS5090 Ink Absorber Full Reset

Canon TS5090 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TS5090. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

  • Service / maintenance warning on the screen or driver
  • Printer refuses to print even with ink available
  • Blinking lights and queued jobs fail
  • Error reappears after restart

How to Enter Service Mode on Canon TS5090

Some Canon series require entering service mode before the ink absorber counter can be reset.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 5 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Frequently Asked Questions

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon TS5090 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply