Blog

Canon TS3680 Ink Absorber Full Reset

Reset Canon TS3680 Waste Ink Counter Easily

Canon TS3680 Ink Absorber Full Reset

Canon TS3680 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon TS3680. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

  • Service / maintenance warning on the screen or driver
  • Printer refuses to print even with ink available
  • Blinking lights and queued jobs fail
  • Error reappears after restart

How to Enter Service Mode on Canon TS3680

If your Canon TS3680 supports service mode reset, follow the steps below before performing the counter reset.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 5 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Need a reset solution?

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

  • Repeat the service mode steps carefully (timing matters).
  • Power-cycle the printer and try again.
  • Close other Canon printer utilities while resetting.
  • Try a different USB cable/port if using PC software.
  • Use the correct Stop/Reset press count for your series.

Frequently Asked Questions

Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon TS3680 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply