Blog

Canon TR9530 Ink Absorber Full Reset

Canon TR9530 Reset Ink Absorber – Complete Tutorial

Canon TR9530 Ink Absorber Full Reset

If your Canon TR9530 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

During head cleaning, surplus ink is routed to internal absorber pads. Canon TR9530 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon TR9530. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

How to Enter Service Mode on Canon TR9530

If your Canon TR9530 supports service mode reset, follow the steps below before performing the counter reset.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 5 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Important Notes

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Common Fixes

  • Power-cycle the printer and try again.
  • Close other Canon printer utilities while resetting.
  • Repeat the service mode steps carefully (timing matters).
  • Try a different USB cable/port if using PC software.
  • Use the correct Stop/Reset press count for your series.

Frequently Asked Questions

How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How long does it take?
Usually a few minutes once the correct steps are followed.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon TR9530 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply