When Canon TR9060 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon TR9060 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon TR9060. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon TR9060

If your Canon TR9060 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Clear the Ink Absorber / Waste Ink Counter

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Important Notes

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Reset tools and instructions

For best results, avoid rushing button presses—consistent timing matters.

If It Doesn’t Work

• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Close other Canon printer utilities while resetting.
• Try a different USB cable/port if using PC software.
• Use the correct Stop/Reset press count for your series.

Frequently Asked Questions