Canon TR8053 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon TR8053. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon TR8053

Some Canon series require entering service mode before the ink absorber counter can be reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Finalize the Reset and Restore Printing

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Important Notes

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

If your model does not show a service mode section, it means no matching procedure was found for its series.

Common Fixes

• Repeat the service mode steps carefully (timing matters).
• Try a different USB cable/port if using PC software.
• Close other Canon printer utilities while resetting.
• Power-cycle the printer and try again.
• Use the correct Stop/Reset press count for your series.

Frequently Asked Questions