Blog

Canon PRO-100 Ink Absorber Full Reset

PRO-100 Waste Ink Counter Reset (Canon Printers)

Canon PRO-100 Ink Absorber Full Reset

If your Canon PRO-100 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

During head cleaning, surplus ink is routed to internal absorber pads. Canon PRO-100 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon PRO-100. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

How to Enter Service Mode on Canon PRO-100

If your Canon PRO-100 supports service mode reset, follow the steps below before performing the counter reset.

  1. Turn the printer OFF.
  2. Press and hold Stop/Reset.
  3. While holding Stop/Reset, press and hold Power.
  4. Release Stop/Reset (keep holding Power).
  5. Press Stop/Reset 6 times.
  6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Maintenance Reminder

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

If your model does not show a service mode section, it means no matching procedure was found for its series.

Frequently Asked Questions

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon PRO-100 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply