Blog

Canon MX868 Ink Absorber Full Reset

How to Reset Ink Absorber on Canon MX868

Canon MX868 Ink Absorber Full Reset

When Canon MX868 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon MX868 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon MX868. Service mode instructions are shown only when a matching series procedure is known.

Perform the Waste Ink Counter Reset

Once the counter is cleared, Canon MX868 should exit the locked state and printing should resume normally.

Important Notes

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

Troubleshooting

  • Close other Canon printer utilities while resetting.
  • Repeat the service mode steps carefully (timing matters).
  • Power-cycle the printer and try again.
  • Try a different USB cable/port if using PC software.
  • Use the correct Stop/Reset press count for your series.

Frequently Asked Questions

How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How long does it take?
Usually a few minutes once the correct steps are followed.

Guide prepared for Canon MX868 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply