When Canon MX710 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MX710. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

Clear the Ink Absorber / Waste Ink Counter

Once the counter is cleared, Canon MX710 should exit the locked state and printing should resume normally.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Reset tools and instructions

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

• Use the correct Stop/Reset press count for your series.
• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.
• Repeat the service mode steps carefully (timing matters).
• Try a different USB cable/port if using PC software.

Frequently Asked Questions