Blog

Canon MX537 Ink Absorber Full Reset

Reset Canon MX537 Waste Ink Counter Easily

Canon MX537 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MX537 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MX537. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

FAQ

How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.

Guide prepared for Canon MX537 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply