Blog

Canon MX498 Ink Absorber Full Reset

Fix Ink Absorber Full Error on Canon MX498

Canon MX498 Ink Absorber Full Reset

If your Canon MX498 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MX498. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

Reset the Ink Absorber Counter

Once the counter is cleared, Canon MX498 should exit the locked state and printing should resume normally.

Important Notes

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

  • Close other Canon printer utilities while resetting.
  • Try a different USB cable/port if using PC software.
  • Power-cycle the printer and try again.
  • Use the correct Stop/Reset press count for your series.
  • Repeat the service mode steps carefully (timing matters).

Frequently Asked Questions

How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
How long does it take?
Usually a few minutes once the correct steps are followed.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

Guide prepared for Canon MX498 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply