The “Ink Absorber Full” / service required message on Canon MX410 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MX410. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

Reset the Ink Absorber Counter

Once the counter is cleared, Canon MX410 should exit the locked state and printing should resume normally.

Maintenance Reminder

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Reset tools and instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

• Try a different USB cable/port if using PC software.
• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.
• Close other Canon printer utilities while resetting.

FAQ