Blog

Canon MX357 Ink Absorber Full Reset

Canon MX357 Printer Ink Absorber Full – How to Reset

Canon MX357 Ink Absorber Full Reset

The “Ink Absorber Full” / service required message on Canon MX357 is common after many cleaning cycles. In most cases, a counter reset restores printing.

Inside Canon printers, absorber pads collect excess ink from cleaning and maintenance cycles. The printer uses an internal counter to estimate pad saturation.

This page is prepared for Canon MX357. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

  • ‘Ink Absorber Full’ / ‘Service Required’ message
  • Support/service code (varies by series)
  • Printing blocked after cleaning cycles
  • Reset required to continue printing

Clear the Ink Absorber / Waste Ink Counter

Completing the reset clears the internal ink absorber counter stored in printer memory and restores normal operation.

Warnings

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Download & get started

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Use a reliable USB connection and follow the steps in order.

If It Doesn’t Work

  • Power-cycle the printer and try again.
  • Use the correct Stop/Reset press count for your series.
  • Try a different USB cable/port if using PC software.
  • Close other Canon printer utilities while resetting.
  • Repeat the service mode steps carefully (timing matters).

Frequently Asked Questions

Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.
Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
How long does it take?
Usually a few minutes once the correct steps are followed.

Guide prepared for Canon MX357 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply