Blog

Canon MX347 Ink Absorber Full Reset

MX347 Ink Absorber Full Reset – Step-by-Step Guide

Canon MX347 Ink Absorber Full Reset

When Canon MX347 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MX347. Service mode instructions are shown only when a matching series procedure is known.

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

Treat the reset as a maintenance step. If your printer has extremely high usage, consider cleaning/replacing absorber pads to avoid overflow.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Common Fixes

  • Use the correct Stop/Reset press count for your series.
  • Repeat the service mode steps carefully (timing matters).
  • Try a different USB cable/port if using PC software.
  • Power-cycle the printer and try again.
  • Close other Canon printer utilities while resetting.

FAQ

Does every Canon model need service mode?
No. The generator shows service mode steps only when the series procedure is known.
Does reset clean the absorber pads?
No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.
How long does it take?
Usually a few minutes once the correct steps are followed.
How many times should I press Stop/Reset?
It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon MX347 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.

Leave a Reply