Canon MP272 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MP272. Service mode instructions are shown only when a matching series procedure is known.

Typical Signs

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

Clear the Ink Absorber / Waste Ink Counter

Once the counter is cleared, Canon MP272 should exit the locked state and printing should resume normally.

Before You Continue

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Need a reset solution?

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

• Power-cycle the printer and try again.
• Try a different USB cable/port if using PC software.
• Repeat the service mode steps carefully (timing matters).
• Use the correct Stop/Reset press count for your series.
• Close other Canon printer utilities while resetting.

Frequently Asked Questions